Old Fashioned Chili Sauce
makes about 3 pints
(America)
Ingredients
4 pounds ripe red tomatoes
2 medium green peppers
2 medium sweet red peppers
1 1/2 cups coarsely chopped celery
1 1/2 cups coarsely chopped onion
1 cup white granulated sugar
1/2 cup light-brown sugar, firmly packed
1 tablespoons salt
1 teaspoon ground cinnamon
1 teaspoon ground cloves
1 teaspoon all spice
1/2 tablespoon mustard seed
1/2 tablespoon celery seed
1 1/2 cups cider vinegar
prepare the vegetables:
1. In a large pot, bring
a large quantity of water to a rapid boil.
Turn off the heat and add the tomatoes, insure the tomatoes are covered
with the hot water. Allow the tomatoes
to stand several minutes.
2. One at a time,
carefully remove each tomato to a work surface, remove the stem and peel. When all the tomatoes have been stemmed and
peeled, empty the water from the pot.
Coarsely chop the tomatoes and place them into the pot.
3. On a chopping board,
halve, stem, and remove the seeds and ribs from the peppers. Coarsely chop the pepper and place them into
the pot with the tomatoes.
4. Add the chopped
celery, the chopped onion, the white granulated sugar, the brown sugar, and the
salt to the pot with the tomatoes.
cook the vegetables:
1. Place the pot over
medium heat and stir the contents until all the sugar is dissolved.
2. Raise the heat and
bring the mixture to a boil; reduce the
heat and simmer the mixture, uncovered for 45 minutes.
3. Add the cinnamon, the
ground cloves, the all spice, the mustard seeds, and the celery seeds.
4. Continue
simmering the mixture, uncovered for 30
minutes longer, stirring occasionally.
5. Add the vinegar and
continue simmering for 1 hour longer, or until of desired consistency is
reached.
prepare for canning:
Meanwhile, sterilize your canning
jars, lids, and seals in separate pans of
simmering water until ready for use. Do not boil. Set rings aside on a clean,
sterile surface leave lids and jars in the hot water until ready to use. Hint: the glass jars can be sterilized in your dishwasher by running them through a cleaning cycle.
can the chili sauce:
1. Working with one jar
at a time, remove it from the sterilizing pan (or your dishwasher), emptying any water out of it and placing it, opening end up on a
clean, flat surface. Add 1 tablespoon of lemon juice per pint into each
hot jar. Ladle your still hot sauce into
hot jars leaving about 1/2-inch headspace. With a clean, sterile knife, remove
air bubbles from the jar, wipe the rim
with a clean cloth to remove any spillage from the jar rim (use a canning funnel to avoid spillage). Center a hot lid on the jar while avoiding touching the unerside. Apply the jar
ring and tighten until it is fingertip tight.
Repeat the process for each jar
until all the jars and hot sauce are used.
2. Place the sealed
jars in a large pot of boiling, insure
that the pot is deep enough to completely submerge the jar in and covers it by
at least 1-inch. Process the submerged jars in the boiling water for about 35
minutes but not less than 20 minutes.
3. Remove jars from the
pot (using a canning jar lifter) and place, lid side up, on a clean dish towel
to cool. Check for positive seal after 24 hours. Lids should not flex up
and down when center is pressed. For any
jars that have not completely sealed,
remove the lids and rings; dispose of the lids you've removed (you can only use
rings once . . . if the seal fails the lids CAN NOT be reused). Check
the jar(s) that haven't sealed for defects (chips on the jar rim, warped rings, etc.) and correct
(for chips on the jar rim, sterilize a
new jar and transfer the sauce to the new jar . . . dispose of the defective
jar). Sterilize the rings and new lids
and center the hot lids on the jars, apply the jar rings and tighten
them until they are fingertip tight.
Reprocess the jars as in step 10
above.